Halloween: Don't Forget To Decorate Yourself...Skull Earrings and Bracelet

 

Not that I'm going many places these days, and I know a lot of people are barely wearing clothes, but I do go out once or twice a week to run errands, and despite the fact that it's still triple digits here in the desert, and I'm still wearing shorts and tanks, that doesn't mean I can't get into the season right? Right! 

So I made myself some seasonal earrings and a matching bracelet. 

Michaels continues to expand their jewelry making supplies and there's not a trip that I make without a few things sneaking their way into my cart. 

Supplies: 

• Skull Charms ( I found mine on clearance at Michaels but they have some other similar beads)
• Silver Connector Links 
• White Marble Beads 
• Filigree Bead Caps
• Rhinestone Dangle Charms
• Small Silver Spacer Beads
• Jump Rings
• Misc Charms
• Jewelry Making Pliers

All of my supplies except for the little star charms, small silver spacer beads, and the swirly flat bead shown at the top of the earring are from Michaels Bead Landing / Charmalong lines).  

I found these on clearance when I wasn't even looking for them. They were up by the register, on clearance, so naturally I bought two sets! 

Step 1: 

If you're a novice jewelry maker, there are tons of great tutorials on You Tube. Here are some on "How to Open and Close Jump Rings") 

Open a jump ring, then use it to attach the skull bead and silver connector link. Sorry this is blurry! One handed photography while trying to hold up pliers with your non-dominant hand is tricky! 

I used the same process to attach the little star charm to the other end. 

Step 2: 

If like it seems 95% of people, you have pierced ears, you'll use the same process to attach an earwire. I'm in the ( I made up this stat) 5% of people who doesn't have pierced ears. Can't. Apparently I'm missing the connective tissue that prevents them from ripping so....it's me and your grandmas and people deathly afraid of needles. 

For us "clippies" the good news is Michaels has us covered. 

Problem Solved!

I use Loctite Gel Glue to adhere these to whatever misc flat backed findings I have. And then you're done! 

Bracelet

I do a lot of my bracelets on stretch cord which is how I did this one. 

Supplies: 

• Stretch Magic Jewelry Cord ( Michaels)
• White Marble Beads
• Filigree Bead Caps 
• Skull Charm
• Dangle Charm 

I always cut off more stretchy cord than I need because I've found it makes it easier to knot and I learned the hard way of trying to be very specific in my measuring only to find out I couldn't quite tie the knot. 

Clamp one end ( you can use an official bead clamp which they sell in the jewelry supplies or I've used clothespins, binder clips, or clamps I found in the hardware section of the Dollar Tree). 

Starting w/ a bead cap string as follows: bead cap, white bead, bead cap, spacer. Lather, rinse repeat until your bracelet fits your wrist. For reference, I have what are considered small wrists and I used 10 of the marble beads. Once you're satisfied w/ the sizing, close your bracelet with a knot. Dab a dot of Loctite Glue and then knot again dot of glue, knot again and trim the ends. 

Open another jump ring and attach your skull charm and rhinestone bead dangle and you're done!

And since it's 2020, my accessories wouldn't be complete with out a mask right? 

I already had this fabric in my stash so it was a no brainer! I've been using a pattern from Sweet Red Poppy to make my masks. 

I hope you've found some inspiration!